There are all sorts of different kinds of wood floor installation available out there today. From simpler installations to more complex sound reduction, every style brings something different to the table. When it comes to installation, you’ll want to enlist a pro to help you out. A professional flooring installer can get the job done faster and easier than you could ever do it yourself. Plus, a pro can also save you money in the long run.
Most people think that the only wood floor installation method for a standard straight wall is to place the first few rungs or planks between the walls horizontally. You have two choices in this method. You can either use long, even spaced boards that resemble planks in your kitchen, or you can use boards that are at least six inches apart, which will resemble half walls. It would be best to discuss these options with Wood Floor Installation San Antonio before the installation begins.
The actual wood floor installation process will depend on where you are installing. If you’re installing hardwood floors in an area such as the kitchen, your options are somewhat limited. Unless you want to build up the room from the ground up, it’s best to stick to the rungs you were able to place in the installation’s first step. Some installers may even choose to place a skirting board between the first and second row of boards. This keeps the room from feeling too open. It also helps the sound deadening qualities of the boards. If you are using them, stay in tune with the rest of the house.
For your hardwood flooring on the second row, make sure they are completely level. If you do not do this, the boards will become uneven and reduce their effectiveness, especially if you have lots of traffic through the room. You may also want to consider adding some space between the boards to help keep the moisture in. If you have a balcony, installing a railing will help keep the moisture in, but you must be very careful if you have a concrete patio. Any cracks in your wood flooring will let moisture in, which will cause damage over time.
Another aspect of installation to keep in mind is that you may want to consider using either glue or nails for your installation. If you decide to use glue, you should follow the directions carefully to avoid the warranty on your hardwood floor. Nails can be used if you can’t get a solid hardwood floor because nails will poke through the boards.
After the boards are installed, the next step is to install the tongue and groove system. This will attach the flat boards. The nails you use for this installation should be rust-resistant. It would help if you started by nailing the first few rows of boards to each other as you lay the first couple rows of tongue and groove boards. This process will take the most time, but it will also give you a very nice clean look.
You should now install the tongue and groove at the same time. When you do, it will form the base for the new hardwood floors. When installing the subfloor, you should follow the instructions given to you by the manufacturer. It is important that you fasten everything together as tightly as possible, especially when doing the rafters. For rafters, it is best to use three or four nails per board, depending on the size of the rafter.
The final step in installing engineered wood is to use a special epoxy to adhere to the subfloor’s engineered wood. Epoxy is a great way to make sure that all of the wood pieces do not move around while you are putting them together. This is the most difficult part of installing pre-finished laminate floors. If you get it right, your laminate floors will look professional, clean, and very durable.